Ok here is what im looking for:
This is going in a 97 cobra
TKO 600
4.6 bell housing
Clutch (one that can be rebuilt is fine)
I also need to know:
What drive shaft do I use? Length?
What cross member do I need?
Are there any other Items needed for the swap?
I have a t56 with 14k miles on it (stock) (i do not have a shifter handle/knob)
03 cobra drive shaft
99 cobra fly wheel ground ready to use
03 cobra fly wheel (needs ground)
Rebuilt Spec stage 2 clutch with ceramic material (good for 500 ft/lbs)
I do not have the trans cross member or speedo conversion
Can do 2k shipped FIRM
This is going in a 97 cobra
TKO 600
4.6 bell housing
Clutch (one that can be rebuilt is fine)
I also need to know:
What drive shaft do I use? Length?
What cross member do I need?
Are there any other Items needed for the swap?
I have a t56 with 14k miles on it (stock) (i do not have a shifter handle/knob)
03 cobra drive shaft
99 cobra fly wheel ground ready to use
03 cobra fly wheel (needs ground)
Rebuilt Spec stage 2 clutch with ceramic material (good for 500 ft/lbs)
I do not have the trans cross member or speedo conversion
Can do 2k shipped FIRM