WTS Steggy Welded, Ported & Powder Coated Plenum $100
I've gone to a Dragon set up so if anyone needs this, here it is.
This started life as a stock plenum and was sent to Steggy for welding and porting, it had the center divider cut out behind the tb blades and further ported and smoothed and then was powdercoated in a gray polished color. It has all the dips welded, the nipples taken out, fully ported then center divider cut and ported some more. Once done the piece was powder coated. There was epoxy used at the bottom to seal a void in the casting as seen in the photos. I don't believe there is too much if any material left to go any bigger on this one. $100 shipped.
http://i39.tinypic.com/255ie4p.jpg
http://i44.tinypic.com/2rway6a.jpg
http://i43.tinypic.com/2daxelw.jpg
http://i44.tinypic.com/21dobki.jpg
http://i39.tinypic.com/ix6qs0.jpg
What it looked like on a polished blower:
http://i44.tinypic.com/9aoaiu.jpg
I've gone to a Dragon set up so if anyone needs this, here it is.
This started life as a stock plenum and was sent to Steggy for welding and porting, it had the center divider cut out behind the tb blades and further ported and smoothed and then was powdercoated in a gray polished color. It has all the dips welded, the nipples taken out, fully ported then center divider cut and ported some more. Once done the piece was powder coated. There was epoxy used at the bottom to seal a void in the casting as seen in the photos. I don't believe there is too much if any material left to go any bigger on this one. $100 shipped.
http://i39.tinypic.com/255ie4p.jpg
http://i44.tinypic.com/2rway6a.jpg
http://i43.tinypic.com/2daxelw.jpg
http://i44.tinypic.com/21dobki.jpg
http://i39.tinypic.com/ix6qs0.jpg
What it looked like on a polished blower:
http://i44.tinypic.com/9aoaiu.jpg
Last edited:
