1999snake said:Bruce,
Do you have any complete sets available right now?
I want the whole kit and the 14 mm bolts.
Please email me at [email protected] since svtperformance.com doesn't send me reply emails.
Thank You
Kory B
Kory:
Email sent!
427Windsorman said:Bruce, would there be any advantage to using 9/16ths Bolts, as opposed to the 14 mm? I know I saw a thread about using a 9/16ths bolt in the Terminator Suspension forum. I wanted to get your take on that. I will likely be purchasing a complete kit from you in the near future here is the thread I am referring to: http://www.svtperformance.com/forums/showthread.php?t=331799&highlight=9/16+bolt My goal is to do the Red Pill, but use your parts in place of the MM parts: http://www.svtperformance.com/forums/showthread.php?t=231900&highlight=red+pill
IMHO it should not be a problem using the 9/16" bolt? If, it fits in the aluminum inner sleeve on my kit? If it doesn't you just need to drill out the inner sleeves a little bit? I sized the inner sleeve to fit the 14mm Ford bolt nicely.
9/16" = .562" Hardware standards make the bolts slightly smaller than that dimension. How much? I don't know? You'd have to measure one? 14mm = .551" That's only .021" of a difference. Granted, that's not a lot? Worse case scenario would be you'd have to drill the I.D. of the aluminum sleeve out a bit?
Hope that helps?
:thumbsup: :coolman: :beer: