I have an 03 Mach 1 with 127xxx and it spun a rod bearing. I couldn't believe with the multiculous maintainence that it did that but it did. So I have had the block cleaned, honed, pistons and rods cleaned and checked, (had one bad rod which was the one that the bearing spun in), heads cleaned and valve job, and crank welded and turned .010. It was basically stock except H pipe, V-Force mufflers and a K&N filter and new clutch and turned flywheel. One rod from ford is gonna cost me $300+ just for a stock rod so I decided I want to go ahead and put h beams and diamond pistons in it and I found a Manley h be and diamond set for around $1200 that I'm gonna buy. I want to b able to put a single turbo on this and be able to drive it whenever I want without much problems. I have never built a turbo motor myself b4 so I don't know what all I will need to do for this car. If someone has a complete build sheet of this I would like to c it. I need to know everything I need to buy and do for this motor. I need to know what size and type of turbo I should run, what kind and where to get a good intercooler for terminator style bumper, I'm goin to prolly run a meth kit eventually. I plan on stuffing the entire motor and porting the heads. I have seen alot of people use a cobra block instead of the Mach blocks. Will mine b ok? I would like to c 500hp+ but don't expect 1000hp I just want a little bit of a street rod I am able to drive on weekends and smoke a few top notch cars. What compression ratio should I go with? Where should I buy gasket kit and bearings? What fuel system should I use? I need complete build info so I can get started on this. Any help would b greatly appreciated. Also since I am a truck driver I won't b building this just buying parts and havin a mechanic do the work for the most part so no worries there lol