UPR anti roll bar ???

[BlueSmokem5.0]

Looking to purchase a UPR anti roll bar kit for my 2011 GT has anyone installed one of these on there car? the only issue I see is they say that it wont clear the stock exhaust?

 

[Aaron@JPCRacing]

Take a look at these-

http://www.jpcracing.com/bmr-rear-xtreme-anti-roll-bar/

http://www.jpcracing.com/trz-motors...t-in-rear-anti-roll-bar-panhard-bar-assembly/

Both of these are a little bit easier on an install and require you to only weld on the rear axle instead of the subframe and allow your exhaust to clear.

 

[slagburn]

Are there any antiroll bars that allow you to remove a link and rely on the factory rear swaybar for street use?
I have a very steep driveway I have to angle the car up so a hooked up antiroll bar is no good and I don't want to street drive without at least the factory rear sway bar.

 

[BlueSmokem5.0]

Are there any antiroll bars that allow you to remove a link and rely on the factory rear swaybar for street use?
I have a very steep driveway I have to angle the car up so a hooked up antiroll bar is no good and I don't want to street drive without at least the factory rear sway bar.

UPR's all new Pro Street Anti-Roll Bar kit for all 05-14 Ford Mustang's eliminates body roll, stabilizes the car and improves the consistency going down the track and on the street. Bolt in mount uses all existing factory locations. Clears the factory and/or aftermarket exhaust and suspension components. Can be used at the track and on the street. $ 449.99

 

[slagburn]

UPR's all new Pro Street Anti-Roll Bar kit for all 05-14 Ford Mustang's eliminates body roll, stabilizes the car and improves the consistency going down the track and on the street. Bolt in mount uses all existing factory locations. Clears the factory and/or aftermarket exhaust and suspension components. Can be used at the track and on the street. $ 449.99

But does it allow the factory rear swaybar to be retained? A week of pulling into my driveway will either break the antiroll bar or tweak the car's chassis.

 

[BlueSmokem5.0]

It says "Clears the factory and/or aftermarket exhaust and suspension components." But I would call before I ordered one just to be sure.

 

[BMR Tech]

Ironically, their new one is strikingly similar to our previous design ARB.

Anyways, you can't use an OEM style/mounted sway bar with a "BMR Style" anti roll bar.

You may want to wait for our new sway bar. It's going to be a street /strip / handling piece....and is going to be very affordable to boot. Re inventing the wheel Like always.