Hey guys, new guy here so hopefully i put this thread in the right section and sorry about bringing up this topic up again since theres plenty of threads about it. According to all the research ive done on here the rear hubs will accept a stud with a .615 knurl without drilling (or so i think) since the 3” moroso studs i bought are giving me a hell of a time. Ive put them in the freezer, put anti seize, stacked some washers and tried to pull them through with a 1/2 impact but they just dont seat all the way. They end up stripping. I have gone through 3 sets already and dont know what to do. Do i have to drill them out with a 39/64 bit?? Some guys on here have said they didnt drill them and they went in just fine? I know arp has some that are the same knurl but arent listed for this car, anybody use those without drilling? Since i know the ones they have advertised for this car are .625 knurl and those do have to be drilled. Any advice would help.