anyone have experience with cutting a panel out of the trans tunnel in such a way it can be put back/taken out again going forward and look halfway decent?
I've got the magnum trans and with my Moroso road race pan and Steeda K you can NOT tilt the trans enough to get to the front shifter bolts/get the shifter out. I am by no means a fabricator type and I'm a little hesitant to cut up such a nice car. It would need to be around 6" long and the width of the shifter but not sure how to make a straight/clean cut and then what would the options be to reattach it?
Having to drop the trans to do anything with the shifter just seems ridiculous and I'm getting too old for this shit. Shifter from tremec has the little seal going bad again so that's going in the scrap pile.
I've got the magnum trans and with my Moroso road race pan and Steeda K you can NOT tilt the trans enough to get to the front shifter bolts/get the shifter out. I am by no means a fabricator type and I'm a little hesitant to cut up such a nice car. It would need to be around 6" long and the width of the shifter but not sure how to make a straight/clean cut and then what would the options be to reattach it?
Having to drop the trans to do anything with the shifter just seems ridiculous and I'm getting too old for this shit. Shifter from tremec has the little seal going bad again so that's going in the scrap pile.