it's an 01 cobra. It has a 5.0 MMR cammed engine and a tremec T56. The tremec solenoid already went bad and replaced so my guess is the Reverse Back-Up Light Lamp Switch. I already ordered it, should be swapped soon. Thanks for your reply.
My reverse lights started flickering at the same time, same pattern. My backup camera (aftermarket) used to work in reverse but it stopped working as well. Any ideas where to start?
My yellow top died and when I replaced the battery, my car did not start. I have the Lethal Performance 99-04 4V Budget Return Style Fuel System (Cobra / Mach-1). I checked all the connections, fuses in the trunk (for the fuel system) under the steering wheel, under the hood (by the battery)...
I need a place or person who can remove a dent on my car. I know dent wizard and the dealers do it but trying to get someone recommended. Thanks
I live in Silver Spring, MD. Thanks
I have an 03 terminator convertible and just bought corbeau seats. I'm trying to figure out how to set up the harnesses since I don't have a roll cage, I only have the CDC light bar. I haven't purchased the harnesses yet.
Pictures are worth 1000 words, if you have them.
Thanks
:shrug:
I just replaced my seats and they are taking some space in my garage. I'm selling them for $500 (front seats only), they are original and in great condition!!!
Will ship if you pay for it.
Library Slideshow by tortolerito | Photobucket
:beer:
I just replaced my seats and they are taking some space in my garage. I'm selling them for $500 (front seats only), they are original and in great condition!!!
Will ship if you pay for it.
Library Slideshow by tortolerito | Photobucket
:beer:
I just replaced my seats and they are taking some space in my garage. I'm selling them for $500 (front seats only), they are original and in great condition!!!
Will ship if you pay for it.
http://s1176.photobucket.com/user/tortolerito/slideshow/
:beer:
I'm selling a Borla Atak (IRS) 99-04 mustang. I had them installed with my old setup. I only had them for 1200 miles, they are stainless steel and look brand new. I'm asking for $600.
I'm selling a Borla Atak (IRS) 99-04 mustang. I had them installed with my old setup. I only had them for 1200 miles, they are stainless steel and look brand new. I'm asking for $600.
I have a speedhut revolution oil pressure gauge that stays at 100. I tried to reset it holding the button while off and turning on the power for 12 seconds but it only goes down to 40. Who knows how to adjust these gauges? Thanks