I need alittle feedback on this, I figure this would be the place to go to get the answer. My tensioner pulley has given out but when I've been looking to replace everyone only has the smooth pulley on the tensioner not the ribbed? anyone had to deal with this problem before?
If anyone is intersted. Have a source making Deletes, Custom Enclosures and Rear trunk lid inserts. There are of great quality too!
Rear Seat Delete--(Plain)$150 + Shp (logo)$215 + Shp
Boxes-- determined by spec of enclosure
Rear trunk insert--(plain)$50 + Shp (Logo) $90 shipped...
I need a 3.5" KB old style puley. If need be I have other sizes to trade just don't have the 3.5". also looking to go 26 spline if anythings out there.
thanks
what is the Avg. Ohm setting for idle and WOT? I tried to set according to the install and it says 1.+ for idle and 4.+ I can't even see 4? is every one using stock settings
Any ideas will be great. I've checked around but can't seem to find any answers. Idle and regular cruise everythings fine. Hit it and let off pressure falls from 35+ to 10-??? If you stay in it it falls on its face...that's how I noticed it, running through the gears..grabbed second and she fell...
Installed the Kenne Bell had this prob before though. Hit the gas let off and fuel pressure drops off. When running the car BAD dead spot? any ideas?
After installing the Kenne Bell I also installed the RR spacer. Now I only have
between 3 and 3.3 inches of pedal. It also is about an inch...