Search results

  1. R

    Low MPH in 1/4 mile?

    Well all, I really thinks its my stock cat-back killing me but will take other suggestions... I can only pull 111 mph every friggin time. Mods: 2.8 pulley UPR CAI Predator tuned my SamBandit O/R Pro-Chamber Best Time: 1.70 60ft 7.92 1/8th 12.36@111 1/4 I launched @ 3500...
  2. R

    More Possible TOB Dealer Issues

    Well, after buying my 03 Cobra two weeks ago, the TOB decided to go. Had a Spec Stage 3 Put in and thats where they found the TOB Shaft cracked in half and called my ford dealer. The dealer said to have it towed to them and under the TSB it should be fixed. Well, 5 days later and they still...
  3. R

    FS/ 01 stock throttle body and upper intake

    $50 + shipping upper intake $40 + shipping throttle body without TPS Thank you, Rich
  4. R

    01 vs 02 motor

    I am buying a 2002 long block from greg in houston with low mileage to replace my blown motor. Are there any pros of an 02 engine over the 01? Thank you. Rich This is to get my truck up and running, I will be building a shortblock in the meantime and hope to have it completed by June.
  5. R

    Thank you ChillFactor !!!!

    For those of you who dont know him, met ChillFactor (Mike) in Waco around last July, and have had to ask him about 200 questions about my Lightning since I just purchased it around the same time. Talked to him on the phone this morning in regards to my blown engine and discussed a few things...
  6. R

    Truck went KABOOM today.......

    Well, just got a new tune in the truck and running 12's. A friend and I were heading to a local car show today and as I start to head up this hill, I eased into the gas at half throttle, truck down shifted- and KABOOOOOOOOM.............. Oil and smoke everywhere. It is only from the Drivers...
  7. R

    James @ RWTD....AWESOME !!!!!!!!

    Well, most of you know by now I was having shuddering/studdering problems only at WOT @ 100mph and my truck would basically stop to run. Well, after talking with James from RWTD for along time on the phone, he said it was probably in my tune. I dynoed my truck and seemed to be about 10 - 15 hp...
  8. R

    Lakewoods = 12's for me (FINALLY)

    Well, Im finally a member of the 12 sec club. I know my truck had it in her, but could not get any better than a 2.1 60ft. My wife bought me some Lakewood traction bars for my B-Day, I got them in afterwork Friday, installed them in 30 minutes with no problems, went to the track and...
  9. R

    Shuddering at 100mph WOT only?

    Well, most of you probably have heard this but my truck is shuddering at 100mph @ WOT only. Idle and up to 100mph is fine, but once it hits that mark, seems to shut off and shake. I have replaced my fuel filter first, then changed plugs to Densos IT22's and these didnt work. I have ordered...
  10. R

    9psi powerdyne on my 94 cobra

    I have a stock 94 cobra with the 9psi Powerdyne kit just put on. It has seen 9psi but it seems to take alot of rpms to reach that point. What will I have to do to hit higher boost sooner? Thanks, Rich
  11. R

    stock 94 cobra with powerdyne?

    I have a stock 94 cobra with the 9psi Powerdyne kit just put on. It has seen 9psi but it seems to take alot of rpms to reach that point. What will I have to do to hit higher boost sooner? Thanks, Rich
  12. R

    94 cobra powerdyne install manual?

    anyone have one, can you please send me a link or email Thank you. Rich
  13. R

    my new (to me) 94 cobra photos

  14. R

    01 Lightning and 94 Cobra

    here is my 01 Lightning and my new 94 cobra. Rich
  15. R

    killeen, texas automax car/truck show

    Hey all, I hope this is the right place to post this. Car/Truck Show sponsered by Automax of Killeen Date: July 10th Place: 804 E. Veterans Memorial Blvd, Killeen, Texas 76543 Trophy Cat: Best Of show($500), Best Import($250), Best Domestic($250) Registration is free: 11am - 2pm...
  16. R

    powerdyne instructions

    Hey all, just got a 9psi powerdyne from a local person. I have searched for instructions online and even on powerdynes website with no luck. Can someone point me in the right direction? Thank you. Rich

Top