More specifically the 1998 white cobra. My fenders are just not pretty and I dont have the money to have new ones put on and then painted. There is a lot of mustangs in the JYs around here and finding a white one seems easy. But if paint colors are not the same AND the fenders not the same I...
What do they go to? They were down in a little hole on the head and in no way could they have got out of there. Each spring had a little aluminum coin with it also,. Looks like they went somewhere.
Pic is where I found 1 set. There was another set farther back in same type hole
read a bunch of the post about doing it. Saying same block and its a cobra engine in a Lincoln. Well I pulled the trigger and got a Lincoln and sat my cobra engine side by side. Just a good side note, both engines use O rings and just about all gaskets were able to be reused. Pan gasket was bad...
I got a 98 cobra and will be pulling the intake and installing on another long block.
Any advice or tips on pulling the intake off? If someone has a good video or has a good picture gallery I can use. I just dont want to think I got all the bolts and have that hidden one and I pry up and break...
I got a whole car in really good shape that I am taking engine to install in my mustang.
I read about the rear IRS being a good donor for a road racer. Any thing else worth my time to take off?
It has air ride suspension.
looking for one with 6 bolt hole, Swapping a lincoln mark8 into my cobra and was told the GT flywheel was what I needed. Just do not want to spend 300 bucks on the flywheel when its only going to be a daily driver back and forth to school while I rebuild the cobra motor.
Had a noise in the bottom end and the rod bearings where messed up. I think I got luck as the crank looks ok. But I dont see what size the rod bearings are, normally the size is on the back,. But I did not see it.
Need the specs and torque for the rod bolts
I got a 1998 Mustang Cobra. Got it knowing it had engine issues. The dealer that sold it to me had a small lot and used a local mech to do work on it. He is NOT a ford guy. But he says it sounds like wrist pins. I have no clue. There is so many things inside these engines that make noise that I...