2010 gt500

Gentlemen, As the title states, I’m back in the market for a toy and I believe it’s time to jump into a GT500. Looking for the following— -08-12 -Vert preferred, but I will look at a hardtop though. -Must be White or Blue (Vista|Kona|Grabber) -Stripes preferred, but will entertain a stripe...

Hi all, I am selling my front and rear set of Steeda lowering springs from my 2010 GT500. I recently replaced these for an Eibach set up, nothing was wrong with them, I was just going for a different ride feel. They have got about 30,000 miles on them and still look new. They provide a 1.2...

Hi all, I am selling my take off M122 with a Steeda 2.6 pulley and a VMP Inlet Elbow. I recently swapped to a ported M122 setup with a 2.2 pulley and figured that this one would really just sit on the shelf. The blower has got about 50,000 miles on it and overall the ribbing on the pulley...

Hi all, I've kind of decided my car is too stiff for the street; it's just not compliant over normal bumps and the car is simply jarred around too much by otherwise pretty good streets. Now, the car is lowered, I think probably 1.5 inches all around and the previous owner put the lowering...

Hi all, I am thinking about upgrading my exhaust mildly. As of now I just want sound quality and I'm not quite there yet to start with headers and such. I am interested in a deeper sound with some volume bump BUT not much much louder than stock. Things like the Roush exhaust, Flowmaster...

Hi all, I am looking for an already ported, low miles, M122 blower preferably from either Posi or Stiegemeier. Let me know what you all have! Thanks.

Hi there, I have been having what I believe to be an issue for quite some time now. However, I am not sure due to not being familiar with specifically how GT500s are supposed to shift. I occasionally have shifts that dont smoothly engage, but they also dont grind; it's more as if it skips into...

Hi all, This is the stock 2010 GT500 2-Piece driveshaft that I am selling. I removed it to install a one piece aluminum shaft, no issues with the stock shaft as far as I could tell. Looking for $150 OBO + buyer pays shipping (could be around $40).

Hi all, I need to change my engine mounts for wear reasons. I am curious if the same year or similar GT mounts will fit the GT500. They seem very similar and I dont want a stiff engine mount. If anyone has changed their mounts to an aftermarket unit, I would like your input as well! Thanks.

Hi all, I am trying to get a feel for what the driving experience is like with an aluminum one piece drive shaft installed. I realize the weight benefit and rotating mass, but what about noise and vibrations? My GT500 is a daily driver and I am struggling to find good info about all of the...