what fuel pressure regulators you guys using with E85?
I use the Fore unit. I bought this whole kit....with the LC3 controller. One of my pumps runs all the time, one of them only runs under boost. I run the 267 pumps, standard PTFE -8/-8 lines, stainless steel filter (128mm)...total cost was a little over $2k. One of the best mods I have spent money on over the years....what fuel pressure regulators you guys using with E85?
Yes, I run dead head setup, putting down over 800 this way. -10 feed to regulator then -10 to a wye block, and -8 to the rear of each rail. I have no EGR or EVAP so I like how clean it is feeding the rear of each rail.I like that design a lot, is it safe up to 800 on E?
you have any engine bay pics of that or a thread I can look at?Yes, I run dead head setup, putting down over 800 this way. -10 feed to regulator then -10 to a wye block, and -8 to the rear of each rail. I have no EGR or EVAP so I like how clean it is feeding the rear of each rail.
you have any engine bay pics of that or a thread I can look at?
I love this engine bay.
Here are some.