2.8 kennebell limit ?

[FEARSNO1]

My bad.... Great numbers regardless.

What was the correction on this sheet? It was cut off of the image.

What pulleys did you use?

SAE correction factor and I was using the 2.5" upper with stock lower

 

[red gt500]

finished installing my kb with the 2.5 upper and 10% lower




it showed 26 psi with the 2.5 upper and 10% lower !

https://www.youtube.com/watch?v=6BMX88XnI5o

and now i maxed the pumps @ 5800 rpm lol

and am near of pegging the maf meter @ 4.8 v

 

[Joewee500]

Obviously a built motor. What rods and Pistons, as well as fuel system details.

 

[red gt500]

Obviously a built motor. What rods and Pistons, as well as fuel system details.

manley h beem and mmr 2500r pistons
stock pumps wit bap 20v and 80 lb injectors

 

[Joewee500]

You feel confident in your build at the boost level? I don't know much about these engines, I'm trying to learn but that sounds like a ton of boost. I'd say my engine is built as strong as yours and my fuel system is better but I'm scared of boost that high. Is my fear stupid unfounded? Will these built engines hold that kind of boost with any kind of longevity?