Hey everybody,
Not a regular poster here, but need some advice now, and I hope you can help me out.
I have gone through 2 warranty replaced rear ends, and two half shafts, one I replaced, one the factory replaced with one of the rear ends. Well, last night, I was chewing up rice mobiles, at the NOPI event here in Atlanta. Had fun doing it, but, on one run, for some reason, I got bad wheel hop.....Normally, I have learned how to not do that, but it happened.
SO!!!
I want to go to a straight axle setup, as I am tired of the IRS BS.
Please give me some suggestions on what I should buy, and any ideas roughly what I can expect to shell out. I am stupind when it comes to rear ends.
My setup is pretty average, not a ton of power, but I do have a strong motor, and my mods have dynoed recently around 450 hp at the rear.
Thanks for the input ahead of time, and I am sure I will have more ???
SVT_SNK
Not a regular poster here, but need some advice now, and I hope you can help me out.
I have gone through 2 warranty replaced rear ends, and two half shafts, one I replaced, one the factory replaced with one of the rear ends. Well, last night, I was chewing up rice mobiles, at the NOPI event here in Atlanta. Had fun doing it, but, on one run, for some reason, I got bad wheel hop.....Normally, I have learned how to not do that, but it happened.
SO!!!
I want to go to a straight axle setup, as I am tired of the IRS BS.
Please give me some suggestions on what I should buy, and any ideas roughly what I can expect to shell out. I am stupind when it comes to rear ends.
My setup is pretty average, not a ton of power, but I do have a strong motor, and my mods have dynoed recently around 450 hp at the rear.
Thanks for the input ahead of time, and I am sure I will have more ???
SVT_SNK