whipple04mach
New Member
Finally finished my 04 Mach 1 project, got it dyno tuned and numbers were 555hp and 474 ftlbs. Does the torque seem low? What could be causing it? On everyone else’s builds, hp and torque are relatively close. Just a curiosity post as the car pulls just fine for what I use it for.
13# boost
11.6-11.8ish AFR
98 octane (93+Torco)
Power mods:
2.3L Whipple Super Charger — stock pulley (3.5 inch)
stock forged crank shaft and aluminum lower block, with federal mogul speed pro main bearings
-Low compression -21 cc DSS forged pistons and rods, moly rings, clevite rod bearings
-Ported and honed Livernois Stage II heads with upgraded valves
- 03/04 cobra front end accessories
-Single blade throttle body
-SCT BA3000 MAF
-ARH 1 3/4 Long tube headers
-SLP catted x-pipe and mufflers
- Fore Billet fuel rails with 60# injectors, returnless fuel system
-Fore Billet triple fuel hat with 2x Ford GT super car 255lph pumps
-Lethal Performance dual FPDM upgrade kit
13# boost
11.6-11.8ish AFR
98 octane (93+Torco)
Power mods:
2.3L Whipple Super Charger — stock pulley (3.5 inch)
stock forged crank shaft and aluminum lower block, with federal mogul speed pro main bearings
-Low compression -21 cc DSS forged pistons and rods, moly rings, clevite rod bearings
-Ported and honed Livernois Stage II heads with upgraded valves
- 03/04 cobra front end accessories
-Single blade throttle body
-SCT BA3000 MAF
-ARH 1 3/4 Long tube headers
-SLP catted x-pipe and mufflers
- Fore Billet fuel rails with 60# injectors, returnless fuel system
-Fore Billet triple fuel hat with 2x Ford GT super car 255lph pumps
-Lethal Performance dual FPDM upgrade kit