Original Owner-Have all Dealer Documents when the car was bought new Window Sticker/Bill of Sale. Price is $64,999.00 OBO. $38K in the engine, transmission, rear end, and suspension.
Go ahead and make me an insane offer you might be surprised!
*7231 Original Miles-Full description of all modifications is in the pictures.(This should answer most questions)
*I Built the Original Engine using JDM Engineering and it has 3700 Miles on it. 1200 in the last 7 Years. JDM Dyno tuned the engine also.
*Full picture and videos of the entire build process and Dyno runs at JDM (806 RWHP 695 Ft Lbs of Torque).
*Tremec Magnum Transmission with SFI Approved bell housing.
*Spec Twin Carbon Fiber Clutch Disc's and Presure Plate with Billet Flywheel.
*Moser M9 Fabricated Ford 9" rearend with through bolt aluminum center section, Wave Trac Gear Driven and 4:11 Ratio
*Acton Machine 3.5" Aluminum Drive Shaft with Sonax Chrome Moly Yoke, 1350 U-Joints
*New Nitto RearDrag Radials P305-35R-20 and NittoFront Tires <250 miles on them.
*New Battery
*Everything works the same as when the car was purchased new. No modifications to the factory wiring harness. No ECM Codes ever! A/C blows ice cold.
* Car passed Pennsylvania Emissions in 2016 with the new engine. Car is located in Pawleys Island SC for the last 7+ years.
* New JDM Engine has never been raced or revved above 6,000 RPM.
Car is stored in a heated and A/C climate controlled garage. Car is immaculate and gets 19+MPG on premium fuel.
Reason for selling is I have too put an elevator in my garage so this has to go ASAP!
Call: 412-477-0843 with questions.
Go ahead and make me an insane offer you might be surprised!
*7231 Original Miles-Full description of all modifications is in the pictures.(This should answer most questions)
*I Built the Original Engine using JDM Engineering and it has 3700 Miles on it. 1200 in the last 7 Years. JDM Dyno tuned the engine also.
*Full picture and videos of the entire build process and Dyno runs at JDM (806 RWHP 695 Ft Lbs of Torque).
*Tremec Magnum Transmission with SFI Approved bell housing.
*Spec Twin Carbon Fiber Clutch Disc's and Presure Plate with Billet Flywheel.
*Moser M9 Fabricated Ford 9" rearend with through bolt aluminum center section, Wave Trac Gear Driven and 4:11 Ratio
*Acton Machine 3.5" Aluminum Drive Shaft with Sonax Chrome Moly Yoke, 1350 U-Joints
*New Nitto RearDrag Radials P305-35R-20 and NittoFront Tires <250 miles on them.
*New Battery
*Everything works the same as when the car was purchased new. No modifications to the factory wiring harness. No ECM Codes ever! A/C blows ice cold.
* Car passed Pennsylvania Emissions in 2016 with the new engine. Car is located in Pawleys Island SC for the last 7+ years.
* New JDM Engine has never been raced or revved above 6,000 RPM.
Car is stored in a heated and A/C climate controlled garage. Car is immaculate and gets 19+MPG on premium fuel.
Reason for selling is I have too put an elevator in my garage so this has to go ASAP!
Call: 412-477-0843 with questions.
Last edited: