3.700 Big-bore Alum 4.6L Block Darton

[sspstangbanger]

Nice proven good 4.6L Alum Block with Darton Sleeve's ready to go!
I bought this from Bill(Moderator on Modfords) he had it in his Turbo Terminator before going to a 5.4L. It held 1,000+ RWHP with no sealing issues!
Comes complete with ARP MAin studs(missing the nuts/washers)
$1,250+ Shipping(about $150-200 w/ins in 48 states)+ 3% Paypal Fee(or send as gift-no fee)
Decided I am not going to build another motor for my Turbo Termi anytime soon so I am just trying to recoup some of my money.
This was well over $3,500 to have built!
Thanks, Rick

 

[Ironhand]

Is the block 3.70 bore or alittle bigger since you said it has been run before.

Has the block been decked and re honed since it was taken apart?

 

[sspstangbanger]

Is the block 3.70 bore or alittle bigger since you said it has been run before.

Has the block been decked and re honed since it was taken apart?

Had 3.700" pistons in it so I would assume 3.705"ish bore haven't measured it myself.
It has not been decked or honed since pulled apart

 

[Ironhand]

Had 3.700" pistons in it so I would assume 3.705"ish bore haven't measured it myself.
It has not been decked or honed since pulled apart

Cross hatching still on the bores? Any cylinder wear at the tops of the cylinders?

 

[sspstangbanger]

Still has cross hatching light scuffs from piston skirts but no visible wear in cyl walls.

 

[sspstangbanger]

Deposit Recieved

 

[1Kona_Venom]

sold...to me:thumbsup: