Right now i have the NGK TR6's in. I forget what gap i have them at (assuming low w/spray). When i put them in i had a 50 hp wet shot (capable) w/stock pulley, dynotuned, x-pipe w/bassani exhaust, and CAI. I have added a 3.0 pulley since then. I would like to get the Iridium's to reduce the missfires. I cant remember what specs i need on the plugs.. any input would be appreciated. Thanks.
Advice needed for plugs and gap (w/spray)
- Thread starter j2schill
- Start date
I just checked with the tuner I will be going with. He told me with a ported SC and pulleys to go with the Autolite Iridiums gapped at .032.
In the .030 to .035 range with your combo will be fine, if you find the car is breaking up at higher rpm close it down to .025 and try again.
Good Luck!
MMR
805 650 1853
Good Luck!
MMR
805 650 1853
i run my tr6's at .025 with 19psi and a 150 shot.
I run .028 w/ my 150 shot. 0.032 w/o.
what is the Iridium heat range i want to be at?
Users who are viewing this thread
