Aftermarket Pullies

[SLAMMEDSVT03]

To All That Have A 2.76 Pulley Does Your Boost Guage Run Past The 10 Mark. Its Been On My Mind Latly That I Have A Smaller Pully But The Guage Doesnt Seem Right

 

[Powershift03]

Yep, mine pegs the stock gauge with a 2.76 pulley.

 

[SVT_4_me]

you should be well over 10 psi with a 2.76... my guage pegs instantly with my 2.93 pulley.

 

[04CobraMatt]

Mine goes way past the 10lbs mark

Look at this pic of my dash http://www.putfile.com/pic.php?img=6323633


Mine hits just underneath the 15lbs mark, and drops off towards the redline.

There is a plastic pin stopping the needle going past the 10lbs mark, you have to remove the cluster, pop-off the boost needle and break off that stopper.

 

[CobraBob]

With a pulley that small you need to either install an aftermarket boost gauge or buy a Ray Hilton boost overlay. That's the only two ways you'll get an accurate boost reading over 10 lbs. http://www.boostoverlay.com/index.php?pgn=wordonthestreet

 

[BadMoFo]

There is a plastic pin stopping the needle going past the 10lbs mark, you have to remove the cluster, pop-off the boost needle and break off that stopper.

there is your anwser.