Does anyone know the real difference between the SCT Big Air MAF BA-2800 and the BA-3000? I cant seem to find any difference.. the discription is the same on both on Leathperformance.
The resolution they can go down to or up to. You want as small as possible and still read. My old setup was 650rwhp and the SCT2800 was too much so I switched to the 2400 and got a clean tune. Now I run a GT500 MAF.
I guess my question would be would the 2400 be good up to around 700 rwhp because that is as high as I think I'm ever going to go. Thanks for the advice in advance.
So whats the 2600 and the 3000 power ratings?
Ok i just purchased a BA-3000 I am looking at running a little over 500RWHP should I be alright? I"m running a Accufab SBTB and Ported Eaton and Ported Accufab plentum.
Yes Lidio is a great tuner. How are you man? I see your local in Michigan to
what would.I need? Look at my new sig. I haven't forging the BA3000 yet. But I alrwsy sold.my 2400That is more MAF capability then you need for your application. A good tuner will be able to get it right, but the tune will be generally less refined. A 2400 would have been better suited to your combination, but at least you will be ready MAF-wise for a much bigger blower when the time comes.
what would.I need? Look at my new sig. I haven't forging the BA3000 yet. But I alrwsy sold.my 2400
No nitrous on this motor. Maybe E 85 but that it.if I got to do this again. It will kill me.A 3000 would be good for you, and will leave open future options. The OP was about 500 RWHP, and the 3000 is overkill for that level. You could be at the upper range of the 3000 if you decide to play with N2O later.