Put my car on the dyno on Sunday and noticed the rear driver side wheel was wobbling really bad. The pass side was fine. It only did it at low speeds and if you would accelerate, it would appear to be fine. Soon as you would slow down and hold a speed, it was showing the wobble again. Bent half shaft? I never heard of them bending, just breaking. What could the other possible problems be?
Driver Side Rear Wheel Wobble
- Thread starter Cravinmohead22
- Start date
Wheel bearing is bad or the laminated axle nut is loose.
Exactly this but likely not a loose nut
Thanks guys. I will pull the hub off and give it a look ASAP.
So should I rule out the half shaft or any other suspenion parts being bent?
Yes if anything were bent it would wobble all the time under any circumstance
Thank you. I will be so happy if its something simple like that.
bonesaw52
New Member
Sorry to bump an old thread but I am having the same issue. Driver side wheel wobbling on the dyno very badly. changed two sets of rims and tires and didn't change it. hub is sold on there and we took off the nut to see if anything moved after the axle nut removal, nothing, solid as a rock. driving around there is no noticeable shake or vibration but on the dyno, whole different story. What did you find to be the issue?
Users who are viewing this thread
