I'm just wonder what pulley I need to run a TVS 2.3L at 700hp+. I was thinking I would go as far as I could with upper only, and hope to get close to 700, but I'm thinking about throwing a lower on to land me in the 700's and avoid belt slip. I'm somewhat sketchy about the lower because of the crank breakage... so I'm not sure yet.
Any experience on this? I am between the 2.6 upper only, I have a tensioner on already but I'm wondering if it is going to slip too much. I could be happy at 700 otherwise. If going with a lower is going to give me 725, no belt slip and no broken snout.. I might go that route.
Thoughts?
Any experience on this? I am between the 2.6 upper only, I have a tensioner on already but I'm wondering if it is going to slip too much. I could be happy at 700 otherwise. If going with a lower is going to give me 725, no belt slip and no broken snout.. I might go that route.
Thoughts?