Has anyone ever fixed or replaced the wiring running from the OEM fuel pump wiring to the OEM fuel pump hat?
The best way to do this is to replace the bad wiring with new wiring. But one end of the wire is plugged into the fuel pump connector and the other end runs to a connector that is riveted into the hat. If I can disconnect at least one of the ends I can minimally run some heat shrink over the areas to protect them. But i'm not sure how to depin this particular connector and I'm not sure how to remove and/or reattach the end that is riveted to the hat.
Any thoughts?
The best way to do this is to replace the bad wiring with new wiring. But one end of the wire is plugged into the fuel pump connector and the other end runs to a connector that is riveted into the hat. If I can disconnect at least one of the ends I can minimally run some heat shrink over the areas to protect them. But i'm not sure how to depin this particular connector and I'm not sure how to remove and/or reattach the end that is riveted to the hat.
Any thoughts?