To wire in the intercooler pump the way that I did your going to need a T-tap, relay, wires and connectors. The relay and T-taps you can get at NAPA.
Below are some pictures of where the wires go and what part of the relay they are wired into.
The connections are marked on the bottom, 87A is not used.
Power wire
Ground wires
T-tap and ignition wire, the wire you use is the solid red wire.
Here is a video of how to use a T tap
T Tap Connector How to use a t tap connector. - YouTube
Here is what it looks like all mounted up
To mount it like I did you have to cut the tab off of the bracket that fits into the fender. Here is a picture of what it should look like once you cut the tab off.
It really isn't that hard to wire it, the hardest part was trying to figure out where everything went. Hopefully this helps some of you out, if you have any questions then just let me know.
Below are some pictures of where the wires go and what part of the relay they are wired into.
The connections are marked on the bottom, 87A is not used.
Power wire
Ground wires
T-tap and ignition wire, the wire you use is the solid red wire.
Here is a video of how to use a T tap
T Tap Connector How to use a t tap connector. - YouTube
Here is what it looks like all mounted up
To mount it like I did you have to cut the tab off of the bracket that fits into the fender. Here is a picture of what it should look like once you cut the tab off.
It really isn't that hard to wire it, the hardest part was trying to figure out where everything went. Hopefully this helps some of you out, if you have any questions then just let me know.