After wiring my DB wideband gauge and LC1 up, my gauge is completely lit up. It is displaying the Innovative logo and the air/fuel text, along with 7.4 I didn't connect the yellow wire from the LC1 or the yellow wire from the gauge to anything. I just taped them off. I also When I hit the push button, it blew the fuse in my add a fuse. The LED does not light up either. I don't even have the LC1 plugged into the sensor yet. Anyone have any idea were I should look first?
Wired it like this:
LC1
black-power
blue-ground
white-ground
yellow- taped off
red-power
brown-white(gauge
gauge
white-brown(LC1)
yellow- taped off
black-ground
red-power
push button/led
black from push button-black on LED------connected these to ground
Red from LED- other black from push button-----connected this to the rest of the 12 volt power of gauge and LC1
I used a terminal strip grounded directly to the engine block so my ground should be fine. I had to screw up the wiring above. Surely someone can straighten this out.
Wired it like this:
LC1
black-power
blue-ground
white-ground
yellow- taped off
red-power
brown-white(gauge
gauge
white-brown(LC1)
yellow- taped off
black-ground
red-power
push button/led
black from push button-black on LED------connected these to ground
Red from LED- other black from push button-----connected this to the rest of the 12 volt power of gauge and LC1
I used a terminal strip grounded directly to the engine block so my ground should be fine. I had to screw up the wiring above. Surely someone can straighten this out.
Last edited: