Is blower ok?

[Spitn03]

Well everyone I joined the blown motor club after a high speed run with my weak ass pistons (#2and #6).

Any way is my blower ok? as the pistons melted and metal went all over the engine in little pieces.

Also is there a way to wash( like a solvent tank) the blower out as well as the heads or what to remove any deposits? What about just having the blower and heads ported?

I am having my motor built right now and I am trying to use at least the heads and blower off of my blown motor. Any advice would be great.

Thanks :rockon:

 

[dynobobstieg]

Make sure you have Bronze Guide liners installed in your heads.

 

[sedanman]

Sorry to hear about it but I have couple questions if you could help. What was your combo and A/F ration on your tune and what was your timming? What were the circumstances that caused the failure? Thanks.

 

[blackvenom77]

Pistons are strong it's the piston to wall clearance that's bad .001!!