Jdm cobrajet whipple 3.4 video
- Thread starter genesmob
- Start date
Nice, WooHoo.
absolute beast.
That's killer.
JimIII@jdm
Well-Known Member
Built 5.4L GT wetsump block sleeved +.070" over bore, fully built GT500 heads w/ Super Stock cam and spring package. Modified Ford GT timing components with JDM upgrades. Joe made just a tick under 1000 RWHP on the dyno a few weeks back. Still pretty mild on his setup but I think he's happy with the results for now!
Well said!!
Ah ok thanks. I imagine it is a 9.5:1 motor then correct?
What pulley combo and rpm are you shifting at?
Thats f'n wild a Verts putting that down. Granted im sure hes caged so he gets the chassis rigidity back, but still... Cat was moving though as soon as the lights went green
15pct lower 3.25 upper. 16 degrees. It auto shifts at 6600 rpm. Only made 3 passes. Will try higher shift pts when I go back. Dynoed over 7000rpm and power was still going up
Last edited:
Yea that's what I figured leaving alot on table with those shifts. That 3.4 car I told you about awhile back made peak at ~7200 with a 2.75 upper/stock lower. Eventually you could pulley it up some to lower peak power and shift it a little higher. Not too high though stock crank doesn't like it. The 3.4 that made 1031 with 6spd is getting a 3k crank now.
Users who are viewing this thread
