Can someone take a measurement from the front face of supercharger pulley to the back of the Mammoth inlet. I need to know the overall depth.
I am trying to install it on my 03 Cobra to 93 foxbody swap project. I'm not sure if I have the room before it hits the firewall on my foxbody.
The measurements that I need are for a KB 3.2LC Mammoth. This is the largest model made for the 03 Cobra. My title is incorrect.
thanks,
Craig
901-493-1099 cell
I am trying to install it on my 03 Cobra to 93 foxbody swap project. I'm not sure if I have the room before it hits the firewall on my foxbody.
The measurements that I need are for a KB 3.2LC Mammoth. This is the largest model made for the 03 Cobra. My title is incorrect.
thanks,
Craig
901-493-1099 cell
Last edited: