MaFia?

[vetteterminator]

I was told that I should run a MaFia if I want to go to 600hp--^ right now I have whipple 140ax, 60lbs, Fore precision Works fuel rails, acufab t-body, full Bassanni, and a 3.10 pulley with a tune and am siting at 510hp. I want to break the mark with just a pulley but to be safe should I get a MaFia?
:shrug:

 

[RRRR03Cobra]

If you have not upgraded your mass air meter, you will definitely need a MAFia or an SCT meter. Otherwiser your maf counts will be through the roof!! I am running a very similar combo and my MAFia does just fine!

 

[AMB]

You will need to upgrade your fuel system also, if you are planning to get 600+HP!!! The BAP is the easyest way to upgrade it.:thumbsup:

 

[1badsvtcobra]

The mafia extender is for you're mass air. If you're MAF gets pegged out you need to add the mafia extender so you can tune the car properly.

 

[Tractionless1]

I pegged with 17psi on an unported blower. Better check them MAF counts ASAP!!

 

[TrickStang37]

mine pegged with an upper only!

sounds like you will probably need a BAP or fuel pumps too.

 

[Black Talon]

Yo better get a MAFia, stacked.

 

[SVTkel]

MY MAF pegged on my 2.93 and port

 

[vetteterminator]

I got a Boost a pump, just asking if the Mafia is all I will need to get to 600hp with the set up I am running and still be safe?

 

[vetteterminator]

You will need to upgrade your fuel system also, if you are planning to get 600+HP!!! The BAP is the easyest way to upgrade it.:thumbsup:

Read the thread, I upgraded the fuel system Rails, injectors,and Boost 'A' Pump

 

[TrickStang37]

Read the thread, I upgraded the fuel system Rails, injectors,and Boost 'A' Pump

you never stated untill recently that you had a BAP.


im pretty sure a MAFextender/MAFia/SCT MAF is all you'll need.

 

[vetteterminator]

thanks for the help

 

[vetteterminator]

So do you guys think with just a Pulley and the MaFia I could make 600+ easy

 

[torched04]

a lot of other guys have made that power, so i dont see a problem.

 

[RAZRS EDGE]

So do you guys think with just a Pulley and the MaFia I could make 600+ easy

Depends on how hard you spin the blower and your other mods. But yes, the 140ax is very capable of making 600+rwhp on these cars.

 

[vetteterminator]

I have a good list of mods and am looking to run 18psi with the mafia so...................................I should be able to make 600 rwhp with the 60#'s the rails and full exhaust?

 

[Justin@VMP]

I have a good list of mods and am looking to run 18psi with the mafia so...................................I should be able to make 600 rwhp with the 60#'s the rails and full exhaust?

You will also need more pump to support 600rwhp, like dual ford GT pumps or a BAP.