Much more than just an Odometer...

[DieselNuts]

So, I was reading through a thread on another forum and this guy mentions that you can turn the Odometer on the Terminator (could work on other models, I dunno though) into a digital speedometer, tach and quite a few other things.

You do this by holding your Odometer reset in WHILE you crank your car. The Odometer will say something and then you can toggle through all the different read outs.

Here is my question: What do all the different readouts mean? I see a fuel preasure, oil presure, speedo, tach, temp. in Celcius and a couple others, but there are a whole bunch that I have no idea what they are.

Does anyone know what Im talking about?

 

[XyX]

:??:

 

[vipergts281]

http://mustangworld.com/ourpics/fcar/dtcodes.htm

Here are the DTC trouble codes

9202 Fuel sender open circuit
9204 Fuel sender short to ground
9213 Anti-theft number of programmed keys is below minimum
A103 or 9232 Antenna not connected-defective transceiver
9317 Battery Voltage high
9318 Battery voltage low
9342 ECU is defective
9356 Ignition run circuit open
9364 Ignition Start circuit open
9600 PATS Ignition Key Transponder Signal is Not Received - Damaged Key or non-PATSKey
9601 PATSReceived Incorrect Key-Code from Ignition Key Transponder (unprogrammed Encoded Ignition Key)
9602 PATS Received Invalid Format of Key - Code From Ignition Key Transponder (Partial Key Code)
9681 PATSTranceiver Signal is Not Received (Not Connected, Damaged, or Wiring)
A139 PCM ID does not match between Instrument Cluster and PCM
A141 NVM Configuration Failure (No PCM ID exchange between Instrument Cluster and PCM)
A143 NVM memory failure
5284 Oil Pressure Switch Failure
D027 SCP Invalid or Missing Data for Engine RPM
D041 SCP Invalid or missing data for Vehicle Speed
D043 SCP Invalid or missing data for Traction Control
D073 SCP Invalid or missing data for engine coolant
D123 SCP Invalid or missing data for Odometer
D147 SCP Invalid or missing data for vehicle security
D262 Missing SCP message.

 

[AaronK]

In answer to your question "Does anyone know what Im talking about?"
Yup, I know what you're talking about and I have no idea what a lot of those numbers are. :beer: I'm very curious to find out what they are though...

 

[Fox-4]

I know when i was messing with that it showed "tcs" and it would change every time I would push the button.

 

[TERMIN8TR]

turn the ignition key while holding down the trip button on the cluster until it enters the diagnostic mode. then scroll through the different parameters and i think mph is on there

 

[04RiceEater]

You just have to hold the buttom down when u prime the car and then it will scroll through all of the options.

 

[DieselNuts]

ahh, here it is. Thanks for everyones input!

http://mustangworld.com/ourpics/News/99hec.htm

 

[vipergts281]

ahh, here it is. Thanks for everyones input!

http://mustangworld.com/ourpics/News/99hec.htm

Did you guys not see the link I posted above. :??: :shrug:

The 3rd post in the thread. http://www.svtperformance.com/forums/showpost.php?p=6883274&postcount=3

 

[DieselNuts]

Did you guys not see the link I posted above. :??: :shrug:

The 3rd post in the thread. http://www.svtperformance.com/forums/showpost.php?p=6883274&postcount=3

yeah, I saw it. The link I posted was a link that was inside your link. You did most of the legwork though.

Thanks!:beer:

 

[vipergts281]

yeah, I saw it. The link I posted was a link that was inside your link. You did most of the legwork though.

Thanks!:beer:

No problem. :beer: