Checking to see if I need a new blow off valve after adding 3.33 pulley and waste gate to my Paxton set up. Read some places the bypass valve with the kit won't work. Thanks.
New BOV needed after wastegate and 3.33?
- Thread starter Bloodykisses
- Start date
The o ring in the bypass valve tends to fail over 12psi or so.
We offer these complete Tial BOV assemblies that come with the flange already welded to the pipe. Great upgrade and only takes a few minutes to do.
We also offer the block off plate for the factory BOV
http://www.jpcracing.com/jpc-paxton-vortech-tial-q-50mm-race-blow-off-valve/
We offer these complete Tial BOV assemblies that come with the flange already welded to the pipe. Great upgrade and only takes a few minutes to do.
We also offer the block off plate for the factory BOV
http://www.jpcracing.com/jpc-paxton-vortech-tial-q-50mm-race-blow-off-valve/
Thank you. Was just getting a little nervous seeing people post about damaged head units because the kits bypass wouldn't open at 2/3lbs so if you're going at 4K coasting or whatever, it's still acting as if it were at 4K wot.
Users who are viewing this thread
