i used a 16" Zirgo 3000cfm pusher
Last edited:
its a Polished Triple Ball-Bearing CompTurbo T80(t4),
.81ar, i used a 16" Zirgo 3000cfm pusher
nice. thats the exact combination i wanted. no problems with the fan and the AC while at idle? that coolant reservoir looks familiar. BMW?
OK thank you...i will check them out... what did u do for an air filter??? mine is very tight..well...only the a/c line really.. i hear u can run very fine screen, but it sacrifices alot of power, b/c it is so restrictive ....
edit: i see that drain kit..and i probably would work... but is 1/2" where i need about 5/8"(running 10an drain)
maybe someone makes a larger one?
Edit2: also...how did u brace your turbo... i need to fab up something to keep the stress off the pipes
please excuse the dirtyness and vacuum lines running all over the place. I just wanted to start the car bad that day so I was in a hurry.
OK thank you...i will check them out... what did u do for an air filter??? mine is very tight..well...only the a/c line really.. i hear u can run very fine screen, but it sacrifices alot of power, b/c it is so restrictive ....
edit: i see that drain kit..and i probably would work... but is 1/2" where i need about 5/8"(running 10an drain)
maybe someone makes a larger one?
Edit2: also...how did u brace your turbo... i need to fab up something to keep the stress off the pipes
faststang, I see the main difference being the size of the turbo's. I think the turbonetics housings are wider than yours, so it makes it look like it is more to the center, but going by the center section they look close to the same.
it dont look too bad. What is that i see in the back... a vacuum block?? for the bov and Gauge?? I think i will need 2 lines to just my bov, so i have to see where i cant find one more. Im using my egr block off plate(drilled&tapped) as one
it dont look too bad. What is that i see in the back... a vacuum block?? for the bov and Gauge?? I think i will need 2 lines to just my bov, so i have to see where i cant find one more. Im using my egr block off plate(drilled&tapped) as one
i called HKS they make a mushroom filter to fit the 5" inlet.
Nice! You know of any suppliers that may have it? or you think i would have to contact hks myself??
edit: maybe this might work? idk about quality of it though Hyperformance -- "TURBO AIR FILTER RED TUBE AIR FILTERS 5"" INLET"
or this K&N K&N AIR FILTER INLET:5"(127 mm) HEIGHT:4.12" RU-5163:eBay Motors (item 390057003028 end time Jul-03-09 10:33:40 PDT)