Just curious which method of pinion angle adjustment are you guys using and why? (Crank or drive shaft)
In for info, I was under the impression you use adjustable upper control to change the "roll" (lack of a better term) of the rear axle.
Link I see referenced often:
http://www.wolferacecraft.com/pinionangle.aspx
^adjustable control arms are only for solid axles. I use the aluminum diff mounts from FTBR.
http://fulltiltboogieracing.com/FT 1200.htm
Ok,so you guys did it based off of the angle of the d.s.? This is the was I did mine as well, just went to baseline suspensions relocated uppers but was recommended to do it based off of the harmonic balancer rather than d.s. angle. Not to say the using the d.s. was wrong but I couldn't figure the difference and I was curious if any of you guys knew why, on a side note what did you guys set you pinion angle at?
The angle of the front joint and rear joint must match. You do not set it based off the harmonic balancer.. dont know how you would even do that... also must make sure the U-joints are in phase when re-installing the shaft