So today I got the old k member out and put in the Team Z k member. Also put in new motor mounts while was at it.
Bought an engine support bar to lift the motor. Worked well. (Damn the car is dirty as heck because of all the metal fabricating I have been doing in the shop. You can see in this photo.)
K Member out
New K member in.
So if things work out with my schedule next weekend, I am supposed to pick up the rearend. At this point it has the ends tack welded, I will get it under the car, measure for the rear wheels and tack on the shock mounts and mockup everything else I need to do before all the final welding is done on the rear end.
The next bit of news is that I was going to run the front Alcon capilers on 13" rotors, well I have changed my mind and I will be going with a 14" setup. I will be using the Baer Eradispeed 14" 2pc rotors. So either next weekend or the weekend after that I will be mocking up the Racecraft drop spindles, Ridetech struts and the Alcon caplipers (don't know if I will have the rotors in by then but we'll see). Then I can start measuring for the front wheels if all goes well.
Bought an engine support bar to lift the motor. Worked well. (Damn the car is dirty as heck because of all the metal fabricating I have been doing in the shop. You can see in this photo.)
K Member out
New K member in.
So if things work out with my schedule next weekend, I am supposed to pick up the rearend. At this point it has the ends tack welded, I will get it under the car, measure for the rear wheels and tack on the shock mounts and mockup everything else I need to do before all the final welding is done on the rear end.
The next bit of news is that I was going to run the front Alcon capilers on 13" rotors, well I have changed my mind and I will be going with a 14" setup. I will be using the Baer Eradispeed 14" 2pc rotors. So either next weekend or the weekend after that I will be mocking up the Racecraft drop spindles, Ridetech struts and the Alcon caplipers (don't know if I will have the rotors in by then but we'll see). Then I can start measuring for the front wheels if all goes well.