Roush TVS which converter is better to use for roll racing 50-170? Stock Converter vs Circle D 3B (Already have both in our possession)
Whats the largest TB we can install on a Roush?
Whats the largest TB we can install on a Roush?
You can install a Twin65 or Twin67 on a Gen1 Roush blower.
I'd say long rear end gears are a requirement to stay in 4th for 170 and in my opinion there would be essentially no difference in the converters from a roll where you'd likely be in lockup anyway.
If you have a Gen1 Roush with the non ported elbow, there's no point in a monoblade throttle body. We need more info on your setup.
I'd say the tighter stock converter would be better... As for the TB, how much power are you planning on?. I have the VMP twin 67 and it's been performing flawlessly. I like it and I'm pushing 800whp.
I'm not quite sure what that means, but if your making less then 650whp the stock twin 60mm is fine...This is a "hold over blower until oil prices rebound" type of build, I am looking into either a Stock Roush or maybe VMP Gen 1 setup. <Honestly whatever i find the best deal on and in the best shape is what ill pick up as they seem to be posted everywhere or every few days/weeks someones got a deal.
I'm not quite sure what that means, but if your making less then 650whp the stock twin 60mm is fine...
Roush TVS which converter is better to use for roll racing 50-170? Stock Converter vs Circle D 3B (Already have both in our possession)
Whats the largest TB we can install on a Roush?