• Welcome to SVTPerformance!

Stock 05+ slot style maf horsepower range

Discussion in 'Engine/Tuning' started by bg90coupe, Nov 15, 2014.

  1. bg90coupe

    bg90coupe Member Established Member

    Messages:
    187
    Joined:
    Mar 22, 2014
    Location:
    Kentucky
    I'm looking to switch to a slot style maf in the near future. My car will make between 550 and 600 rwhp. Will a stock 05+ slot maf in a 110mm housing support that much power? According to vmp it will be right on the edge which I don't want to be. However lethal performance says a gt500 maf (same as stock 05+ maf) will support 800rwhp in a 4" tube. That's a big difference. My other option is the vmp3500 in a 4.25 Id tube which I know will work but it is the more expensive option.
     
  2. bg90coupe

    bg90coupe Member Established Member

    Messages:
    187
    Joined:
    Mar 22, 2014
    Location:
    Kentucky
    Anybody?
     
  3. MalcolmV8

    MalcolmV8 Well-Known Member Established Member

    Messages:
    7,331
    Joined:
    Mar 27, 2003
    Location:
    Tampa, FL
    I have a GT500 slot sensor (05 - 10) in a 123 mm (4.8") tube if I remember right. It's the Whipple Crusher intake. I make low 700s whp around high 900 MAF counts. Idle and low end is great too. I'd go that route instead of the GT sensor which sounds much more limiting.
     
  4. svt4me38

    svt4me38 TEAM VMP TVS Established Member

    Messages:
    5,573
    Joined:
    Aug 19, 2009
    Location:
    Bealeton, Va
    I run a 05 crown Vic Maf in my 123 maf housing and 5inch intake. I made 837/741 but it was close to maxed.
     
  5. bg90coupe

    bg90coupe Member Established Member

    Messages:
    187
    Joined:
    Mar 22, 2014
    Location:
    Kentucky
    Are you running a mafia?
     
  6. svt4me38

    svt4me38 TEAM VMP TVS Established Member

    Messages:
    5,573
    Joined:
    Aug 19, 2009
    Location:
    Bealeton, Va
    No sir, no mafia
     

Share This Page