Stock Eaton Question...

[ssketer4]

I did a search, but didn't find much. I have a Metco 6# lower pulley setup that I'd like to use with the the stock upper pulley. Is this OK to do? Are there any other supporting mods needed? I realize that I will need a tune, since I'm installing Mac LT's with O/R x-pipe at the same time. Any sound advice is appreciated! TIA!!

 

[CobraRyan]

you should be fine if its a stock eaton. That would be the same as running a 2.8/stock lower. Just make sure you get it tuned.

 

[ssketer4]

....I'm thinking of talking to Rick at ATS after I get this all installed....a lot of guys seem to be happy with his work....?

 

[gray03beast]

....I'm thinking of talking to Rick at ATS after I get this all installed....a lot of guys seem to be happy with his work....?

you wont be sorry rick is great

 

[2003 SVT ROUSH]

SOunds good just make sure you grab a bigger alternater pulley

 

[ssketer4]

SOunds good just make sure you grab a bigger alternater pulley

I was wondering about that. Maybe extra idlers too...?

 

[Posi]

+1 on the alt. pulley. If you have the money then do the idlers now also.

and +1,000 on ATS.

 

[spincobra03]

+1 on the alt. pulley. If you have the money then do the idlers now also.

and +1,000 on ATS.

Plus 2 on the alternator pulley. I had the same setup on my 03 that you want to run. I hear rick is good, you should be fine but do me a favor dont buy anything until you bring it to him because this way you can get the recommended supporting mods and dont end up buying things you might not need. GL