Looking for some advice/setups to get rid of swirl marks and prevent them on my all black car. What kind of buffing setups should I look at getting into and what can I use to remove the marks?
Wash very well, then clay bar the whole car. This is important because it removes the contaminates on top of the clear coat so you polish the clear and not dirt on top of the clear. Polishing by hand would not work that well at all, and apply jet seal and wax by a buffer will work it more into the paint better than by hand. There are about 10 different pads, from compounding pads to final wax pads. I use an orange pad for polishing, and a white pad for sealant/wax.So I would most likely clay bar it, give it a good through wash and then begin. Do the swirl removers, seal it with jet seal (can this be done with a buffer?) and wax it. I love to use collinite on my car.
What pads do you use for the swirl remover vs sealant/wax?