The big DAY!!

[bransharksfan]

So last night I dropped the L off for its retune.

NEW MODs:

8lb. lower
Ported S/C
FTVB 2CR

The last tune I had a coil pack acting up! So we shall see I got 405 HP last tune. I have been told to expect 470 this time around!

Its all in APEX MOTORSPORTS hands now!! COME ON ED bring this baby to life!!

I will post up the exact results once I hear the word!

 

[hemislayer99]

Good Luck! I didn't know they made a pulley that big?!

 

[svtpwd831]

:rockon: :rockon: good luck brandon.....hope yu get some kick ass numbers.... :rockon: :rockon:

 

[Fade 2 Black]

Best of luck to you Brandon!!!

 

[lightninmike]

your gona run an 8lber on an eaton??? Let me know how that works out as i was gona pulley down to a 4lber. And with stage 2 cams and heads i think you will be a bit higher than that. Hell mine feels like its at about 430 at the floor right now and i have just about the same setup as you

 

[Mach0ne351]

man, talk about copy&paste lol

 

[baer42]

Just get a 10lb lower

 

[bransharksfan]

man, talk about copy&paste lol

Its easier that way!! epper:

 

[ChrisNelson]

best of luck to you bro.

 

[bransharksfan]

thanx guys I just hop the heat is not too bad!

 

[ChuteboxeL03]

how do you like the ftvb 2cr, hit hard?

 

[boca ron]

your gona run an 8lber on an eaton??? Let me know how that works out as i was gona pulley down to a 4lber. And with stage 2 cams and heads i think you will be a bit higher than that. Hell mine feels like its at about 430 at the floor right now and i have just about the same setup as you

mike, the 8 works good on a cammed built motor L especially if the eaton has been ported. on drag radials i run mid to .70 11s @ 119 with that combo.

 

[Nvr_Spds]

Good luck brandon. If you need to host your dyno sheets, just send em my way.

 

[I'D WIN]

Good Luck! I didn't know they made a pulley that big?!

Lol...Did you know they made a 14# lower?

 

[Mach0ne351]

put a 30# lower pulley brandon!!! go big!!! haha

 

[Fade 2 Black]

Atsa bigga pulley!! Who made that?!?

 

[I'D WIN]

I had a buddy of mine make it for me using his CAD equipment and a block of billet aluminum.

 

[Fade 2 Black]

What is the diameter?

 

[I'D WIN]

It measures 11.25 inches. I am [will be] also running it with a 150 shot of NOS.

 

[bready]

good luck Brandon!