I will try to not make this too long winded but I wanted to get my Terminator brethrens advice. So I bought my 03 a while back from a dealership that knew dick about the mods that were done to her. I have been discovering as I go along what is done as well as what I want to do with it. It's been 13 years since I've owned a Cobra so I know alot has probably changed in that time span. I'm wanting to make 650-700rwhp on 93 pump gas. The blower I'm wanting to go with is the TVS gen 3R(gotta have some blower whine). I will list my current mods that I know are on the car.
-Stock upper pulley, 8# lower?(15# of boost)
-Accufab TB
-8.8" solid rear with 4.56 gears(which gear is recommended for 700rwhp?)
-Welded Sub Frame Connectors
-Koni Shocks/Springs
-T-56 with steel flywheel and McLeod twin disk (800hp rating)
-Bassani mid length headers and catted X pipe, SLP loudmouth CB
-Fluidyne heat exchanger
Everything else is either stock or needs to be replaced, what are your suggestions for further supporting mods with the TVS gen 3R in mind?
-MAF sensor?
-CAI(the one on it is busted up)
-Fuel injectors?
-Boost a pump sufficient?
-Has Innovative wide band that only reads Lambda!?
-Most importantly what's the best way to get this thing tuned(I live in middle TN)
Bless your heart if you've made it this far and I welcome any suggestions you fine gentlemen might have in regards to how I should tackle this pig! Thanks!
-Stock upper pulley, 8# lower?(15# of boost)
-Accufab TB
-8.8" solid rear with 4.56 gears(which gear is recommended for 700rwhp?)
-Welded Sub Frame Connectors
-Koni Shocks/Springs
-T-56 with steel flywheel and McLeod twin disk (800hp rating)
-Bassani mid length headers and catted X pipe, SLP loudmouth CB
-Fluidyne heat exchanger
Everything else is either stock or needs to be replaced, what are your suggestions for further supporting mods with the TVS gen 3R in mind?
-MAF sensor?
-CAI(the one on it is busted up)
-Fuel injectors?
-Boost a pump sufficient?
-Has Innovative wide band that only reads Lambda!?
-Most importantly what's the best way to get this thing tuned(I live in middle TN)
Bless your heart if you've made it this far and I welcome any suggestions you fine gentlemen might have in regards to how I should tackle this pig! Thanks!
Last edited: