TSS oil pump ger install questions

[1Quick4.6]

Couple things no covered in the other threads.
1. I know the MMR gears have a correct front and back direction to be out in the pump what about these TSS gears ?
2. is the correct torque spec for the backing plate on the pump 100 in/lbs
3. I see the bolts to bolts holding down the pump have an angle value, are they one time use?

 

[1Quick4.6]

Anyone??

 

[jymboslice]

I installed my TSS gears facing you or facing toward the back of the car.

 

[evil281]

Couple things no covered in the other threads.
1. I know the MMR gears have a correct front and back direction to be out in the pump what about these TSS gears ?
2. is the correct torque spec for the backing plate on the pump 100 in/lbs
3. I see the bolts to bolts holding down the pump have an angle value, are they one time use?

I had MMR opg so I am not sure which way you should face them
I used a torque spec if 89in lbs on the torx bolts.
I used the factory bolts on the pump. Did not need to replace them. Just follow the torque steps.

 

[Blazer707@TBR]

TSS logo facing rear of car, 89 in/LB's and no need to replace.

 

[1Quick4.6]

TSS logo facing rear of car, 89 in/LB's and no need to replace.

Sweet I put them in that way and used 96in/lbs it's was between the 89 and 100 I have seen online

 

[Blazer707@TBR]

Yea you will be just fine.