Been running the cheap parts store breathers, but the lip is tearing up the rubber grommets when I pull them out. Do they make screw in breathers that will fit? or do I need to remove the grommets and buy a screw in adapter for the filters?
I do have the CFM breather cap in addition to the other breathers.You can look into CFM breather/oil cap
Get the real deal bro.... I have two of these. Comes with drain hose.
Did you run one on each valve cover or do you have 1 on 2 different cars?
03 Mercury Marauder
I like the idea of catch cans but I don’t like the looks of all the lines. I think it looks to busy under the hood. But I may eventually go that route to lessen the smell.
2 hoes is enough for me.I originally had one..... But needed two. U can run two hoes from each valve cover to one can but imo its just better to have two so the engine can breath better.
I was going to say not everyone can afford two hoes.2 hoes is enough for me.
I'm using the Shelby GT500 Single Valve Oil Catch Can CSS kit from UPR. (Best Catch Can on the market IMO). The driver side is basically a breather. So my setup consists of breathers on both sides. CFM breather is on the other side where the oil cap was in the valve cover. No residual oil issues what so ever!You guys running breathers, one or both sides?
When I had my 2014 CTS V Coupe UPR didn't have a standard kit that they sold. But they were able to make a kit up for me out of gm kits that they did sell. You should give them a call and tell them what you need and want. I'm 99% sure they can put something together for you.I have a UPR on my 150, works good. I can't find one for the Cobra.