Wtt

LINOGT

LINOGT

Member
Established Member
Joined
Feb 14, 2004
Messages
944
Location
JERSEY CITY
Looking to trade my 04 Lightning, looking for something nice stock low milage.

2004 with 30k clean title. Stock block.

engine:

dynatech full exhaust with bassanis catback.
255 pumps
#60 injectors
metco fuel rails with hoses and fuel regulator
tr6 plugs
dmr oil catch can(polished)
jlp inter cooler revisor
jlp intake(polished)
2400 big air
mp bracket with metcos dual bearing idlers (polished)
polish tb single blade
#4 lower
freshly rebuild and polished kb 2.3 with jlp metal sheet intake(polished)
polished accessories
carbon fiber accessories
viper alarm
ftvb with 4x4 oil pan
T/A grille cover
jlp traction bars
jlp drive shaft loop

tce big brake kit
Harley upper
hid all around
cervinis hood and wing
Lund roll pan
djm upper and lower control arms
hotchkis hp 400 shock and sway bars
beltech flip kit with shock extenders

centerline wheels with new nittos
alpine system/gps/dvd/bt.
auto meter gages
center console
racing seats
custom dash pod
jdm e-fan/navi water pump
f-20 trans cooler upgrade with remote filter.
moroso trans pan.
and more.....

https://cid-fb04dea4747feafe.photos.live.com/browse.aspx/trade ^55^6
 
Last edited:
silver93

silver93

Member
Established Member
Joined
Jun 9, 2008
Messages
411
Location
louisiana
i dont have a terminator but if thats your lightning in your post that thing is sweet looking. free bump for a tough looking lightning man
 
silver93

silver93

Member
Established Member
Joined
Jun 9, 2008
Messages
411
Location
louisiana
what would you sell the truck for out right? thinking of getting rid of my 67 mustang if i do i want to get a terminator or maybe another lightning

013-2.jpg
 
Last edited:
stang-kag

stang-kag

Member
Established Member
Joined
Oct 3, 2009
Messages
104
Location
Duncan, OK
You interested in a trade?
042-2.jpg

046.jpg

049-2.jpg

0929101850-00.jpg

20100825114749.jpg

IMG_1912.jpg

IMG_1945-3.jpg

IMG_1943-3.jpg

IMG_1917.jpg



I am the 2nd owner of this beautiful cobra, she’s torch red and in superb condition. I purchased this car Mar 28, 2009 and I bought it off ebay from a guy in Dallas, TX…It was all stock except a ported eaton blower and magnaflow exhaust. I had been looking for this exact car for a long time when I found it, a low mileage car (13,900) that hadn’t been torn into and raced into pieces. “I knew I was going to mod this car and try to have a very fast car built” so instead of going to TX and picking the car up I had the car trailered to JKS Performance of Mansfield, TX (a suburb of Dallas Fort Worth, TX) to be modified!!! I first started off with :rockon:

Stage 3 Modular Mustang Racing (MMR) Heads
Stage 3 COMP camshafts
Stage 5 ported eaton
BBK Longtube Headers
(I’m sure im forgetting some things) but this setup on 91 octane dyno’d @ (519rwhp on mustang dyno) on 17 lbs of boost!

This wasn’t netting me the power level I wanted to be at so I made some fuel upgrades, some suspension upgrades and went to a kb 2.2 blower instead of the ported eaton…Granted I could of made a lot more power with a 2.8 KB mammoth or a 3.4 whipple, I chose the 2.2 because I love the sound they make since they are spun so hard and I got this at an amazing price! This upgraded blower made (583 rwhp on mustang dyno) on 91 octane and 18 lbs of boost!

Happy but not completely impressed with those numbers, I wanted more so I decided to go with twin turbo…Even though most people would have stopped at that point and just enjoyed the car as is ( because at this point I had owned the car for about 6 months and still had not driven it) I had Josh the owner of JKS Performance rip off all the stuff I didn’t need anymore to convert the car to a twin turbo setup…I sold most of it through SVT Performance.com and the other stuff I either sold through his shop or I still have at his shop in a box! I then contemplated which turbo kit to go with, I decided to have a custom Twin 67mm Turbo kit fabbed up by Majestic Turbo in Waco, TX. The Turbos are 67 mm Garrett turbos that are good for (750 hp) each. The hot and cold side piping along with the upper sheet metal intake was fabricated by Josh and his employees at JKS… The intercooler is from HP Racing in New Mexico, it was all then sent off to a powder coater and then installed along with all the the parts listed below to make a breath taking view… This setup looks similar to the kits made at HPP Racing in Lewisville, TX. The battery has been relocated to the rear trunk to allow space for the turbo!

Work done by JKS Performance: All parts were purchased NEW!!! No shortcuts were taken at all on this build… List of most parts installed are as follows


ENGINE:
'03 Cobra Longblock
'03 Cobra Manley H-Beam rods
'03 Cobra forged crankshaft
Manley forged pistons
MMR Stage 3 ported cylinder heads
Stage 3 Comp cams
Sullivan lower intake
JKS Performance custom sheetmetal upper intake
Accufab throttle body

TURBO KIT:
Twin Garrett 67mm turbo's
Tial 38 mm wastegates
Tial blow off valve
HP Performance front mount intercooler
JKS Performance cold side piping
Turbosmart E Boost 2 boost controller

TRANSMISSION:
Mike's Trick Shift 4R70W (with warranty)
Mike's Trick Shift custom converter
Baumann Transmission Controller

REAREND:
8.8 Ford rearend
Ford Racing carbon filter clutched differential
31 Spline Alloy USA axles
3.27 gear ratio netted “20.6 mpg on the drive home at 68 mph!”

FRONT SUSPENSION:
Tubular K-member and A-arms
Maximum Motorsports Coil over kit and Caster Camber plates
Tokico 5-way adjustable struts

REAR SUSPENSION:
Wolfe Racecraft upper and lower control arms
Spherical Rearend housing bushings

BRAKES:
'03 Cobra brakes

FUEL SYSTEM:
Ford GT Supercar fuel pumps
Twin FPDM upgrade
1/2" fuel line
Sullivan fuel rails
80 lb/hr Ford Racing Injectors
SCT TUNER WITH 3 AVAILABLE SETTINGS
AFTER THIS BUILD IT DYNO'D ON 91 OCTANE THROUGH THE NEW AUTO TRANNY ON JOSHS MUSTANG DYNO AT 605 RWHP AT A SHORT RUN OF 6500 RPM'S... ROUGHLY 690 RWHP ON A DYNO JET DYNO...THIS WAS MY STREET TUNE AND I WAS HAPPY WITH THAT SO I WENT AND PICKED IT UP THAT NEXT WEEK, THE PLAN WAS TO GET USED TO THE CAR AND BREAK IT IN THEN GO BACK TO TEXAS FOR A FULL OUT RACE FUEL TUNE ON HIGH BOOST BUT I NEVER GOT THAT FAR...DUE TO A RECENT CHANGE IN JOBS:bash:, IM NEEDING TO DECREASE MY DEBT AND UNFORTUNATELY NOT BE ABLE TO ENJOY ALL THE HARD WORK, TIME AND MONEY THROWN AT THIS BEAUTIFUL COBRA, SO MY LOSS IT YOUR GAIN...IF YOU WANT ANY OF THE THINGS IVE TYPED ABOUT THIS CAR AND ITS BUILD TO BE VERIFIED DONT HESITATE TO CALL THE SHOP OWNER OF JKS PERFORMANCE @ (682) 518-1785 ASK FOR JOSH! HE KNOWS THIS CAR BETTER THAN I DO, AND IT WAS JUST COMPLETED 2 WEEKS AGO!!!
THE CAR WAS DRIVEN FROM TEXAS TO MY HOUSE IN OKLAHOMA, DRIVEN AROUND TOWN ABOUT 20-25 MILES WORTH AND THEN CLEANED AND PARKED, HAS NOT MOVED SINCE THEN. CURRENT MILEAGE ON CAR IS 14,426.9= "VERY LOW" ONLY 225 MILES ON BRAND NEW BUILD 200 OF WHICH WERE AT 68 MPH ON A HWY
SERIOUS BUYERS WILL BE EMAILED AN ENTIRE BUILD SHEET WITH ALL INVOICES...I HAVE NOTHING TO HIDE!!! THIS CAR WAS BOUGHT ON 3-28-2009 AND TOOK UNTIL 11-12-10 TO COMPLETE...

THE MOTOR IS A FRESH BUILD, THE AUTO 4R70W IS BRAND NEW WITH A WARRANTY, THE TURBOS ARE BRAND NEW CUSTOM BUILT FROM MAJESTIC TURBO IN WACO, TX AND I JUST CHANGED JOBS TO BE HOME WITH FAMILY MORE, SO IM LOOKING TO DOWNSIZE MY DEBT... I AM WILLING TO TRADE FOR A SVT LIGHTNING IF YOU HAVE ONE OTHER THAN THAT, IM NOT LOOKING TO TRADE FOR ANYTHING ESLE...THANK YOU AND PLEASE EMAIL ME AT [COLOR="red"][email protected][/COLOR] IF YOU HAVE ANY QUESTIONS OR TEXT OR CALL ME AT 918-325-1704 KYLE
RECEIPTS FOR OVER $56,000 IN CAR
ASKING $40,000
 
LINOGT

LINOGT

Member
Established Member
Joined
Feb 14, 2004
Messages
944
Location
JERSEY CITY
wow..very nice ride! I'm trying to get away from this, I'm looking for something near stock , low mileage just to cruse on Sundays. Its also out of my price range.
 

Users who are viewing this thread

Total: 2 (members: 0, guests: 2)


Top