Hey guys... I searched around here to try and find the answer to my question, but didn't seem to get anywhere. I have looked on BF's site, and my combo doesn't have a size listed, and I can't seem to make much sense of the chart on Metco's site... So. What size belt (round-about) should I be running with my setup?
I am currently running a Gates K080745 with a BF 2.76" upper, 4 piece BF idler set with snub idler, and a 2lb Metco lower will be going on next. Any insight into what I need to run would be much appreciated. I looked under the hood today and the tensioner is a bit off of the center mark, to the right, towards the raised side. I'm not sure if I should check that when the car is running or not. It has sat since last night when I checked it today.
Thank you for the help.
I am currently running a Gates K080745 with a BF 2.76" upper, 4 piece BF idler set with snub idler, and a 2lb Metco lower will be going on next. Any insight into what I need to run would be much appreciated. I looked under the hood today and the tensioner is a bit off of the center mark, to the right, towards the raised side. I'm not sure if I should check that when the car is running or not. It has sat since last night when I checked it today.
Thank you for the help.