I mean, I could see his point if you're the typical older person that buys a Corvette then drives it around like it's a Prius. :lol1:
700RWHP NA Corvette C6 z06 20mph - 160mph Test HITS!!!
- Thread starter Scorch
- Start date
I mean, I could see his point if you're the typical older person that buys a Corvette then drives it around like it's a Prius. :lol1:
Bob04cobra04
Banned
Nope. The Fast will make 1-2 hp more.
I know the FAST 102 makes marginally more than the LS7 intake on a stock or mildly built engine, but I find it hard to believe there are no more gains to be had once you're flowing 400cfm through the heads with a .700 lift cam.
Bob04cobra04
Banned
Yeah he posted this before. STD numbers. He refuses to post the corrected numbers. Still one bad ass Z!
Bob04cobra04
Banned
There have been numerous tests to prove otherwise. You may get a few more hp but hardly worth the 900 they cost.
My point is, its not a one dimensional drag car. DR look stupid on a sports car. MO.
A84gt
New Member
You're confused
? 642rwhp < 700rwhp ?
I guess I'm rounding my dyno sheet wrong.
Still a sick Z06 though.
Am i supposed to look for Road Race tires and not run the Drag Race tires since it's not a drag car?:dw:
I guess I'm rounding my dyno sheet wrong.
Still a sick Z06 though.
I'm not sure I understand your point. My car is a road race car with DR on all 4 corners (granted the 295's in front look different at the track).
Am i supposed to look for Road Race tires and not run the Drag Race tires since it's not a drag car?:dw:
Last edited:
I agree with the STD numbers, but it says in the description 93 octane. He says he runs meth with 109 octane now. I would think he would make more power now..maybe not 700 rwhp though.
I am willing to bet a MAMO 102/102( MAMO is the #1 FAST porter in the LS Community) will pick up more than 1-2hp at any RPM let alone peak HP with his setup.
This is from jason at Katech.
FAST LSXR 102mm LS7 intake manifold dyno test results - Corvette Forum
427ci..heads and cam..E85....stock intake 615/558 then to a FAST setup with 102/102 NOT EVEN PORTED made 631/579. I agree the cost is high for the returns but I could never see it only making 1-2hp more. One member even did the same and while only picked up 3-5hp with a ported fast 102 on his LS7 at one point in the graph picked up almost 29rwtq. There are LS1 cam upgrades that barely make 30rwtq gains lol. Again I agree that the intake is a lot of money..i agree 700rwhp is gonna be a tough goal..
A properly setup C6Z will do this to people scorch... I'm currently doing pretty much the same setup as him... Only difference will be my built C6 IRS with 4.10's on a 28" tire...
Last edited:
^^^ haha
The hardest thing to believe about this video for me was the car dead hooked from a 1st gear roll and didn't seem to have any spin on any shifts.
That thing must be fun
Bob04cobra04
Banned
A properly setup C6Z will do this to people scorch... I'm currently doing pretty much the same setup as him... Only difference will be my built C6 IRS with 4.10's on a 28" tire...
Did you miss the part where everyone that is calling bullsh*t on the 700rwhp has a built a Z as well. Good luck getting 700rwhp with your "similar" setup.
oke:
Did you miss the part where everyone that is calling bullsh*t on the 700rwhp has a built a Z as well. Good luck getting 700rwhp with your "similar" setup.
See I know more people with C6Z's with well over 600rwhp... Whoever's car only made under 600rwhp with E85 & 13:1CR should ask for money back from the builder because he got ripped off hard... Now not saying the dyno wasn't a happy one but this car makes over 650rwhp on any dyno... From what I've seen in this thread no one that has a built C6Z has put as much as him into his... It went 143mph before he had his work done to it... He has a seriously large cam in it that it was lucky enough to be told the specs... So I have no doubt about Scorch's car... Who here besides Scorch and I are running a meth kit on their NA LS7...? Also his car is 13.5:1 not 12.5:1...
Last edited:
Bob04cobra04
Banned
i have seen 650rwhp with e85 and HUGE cam. People have been asking him to post his corrected numbers for about a year now on 15 different sites. He has never responded or even acknowledged anyones requests. He won't because he can't, because he is full of shit. i would love for him to prove me wrong but I already know better at this point.
Last edited:
All I can do is laugh at your responses because you are clueless :-D
Users who are viewing this thread
