Recent content by 04COBRAinJapan

Need help with this overheating problem. I pulled the thermostat and it was indeed broken. The copper shaft separated. No problem odered a replacement, installed and no workee. Car overheated again, seems like the new thermostat is not opening. Also, the heat did not work with the new...

How difficult is it to replace the rear wheel speed sensor. I think mine is bad on the drivers side. I had a flat and the ABS light came on for like a day. Replaced the tire and it went away for about three days then came back on and has remained on. (about 3 months now)

Are BBK CAI's garbage for our cars? I feel like my car has lost a little of its responsiveness under WOT, Also my Gas milage went down to about 150 Miles Per Tank after the install. Any help would be gr8.

Im trying find out why my gas mileage is down, and the car seems to have lost a little bit of its power. (seems like a sluggish response when i get on it) Ive changed the fuel filter, plugs, cleaned the MAF,then changed the MAF for troubleshooting, and changed all of the O2 sensors (O2 sensors...

Does anyone have any troubleshooting info on the O2 sensors. Im in japan and cant go to the local autozone to check eng codes. The dealer over here will charge 22000 YEN (about 220 dollars) just to hook up the scanner. my symptoms are: Horrible gas mileage (about 8-10 gallons in the city)...

Does anyone have any troubleshooting info on the O2 sensors. Im in japan and cant go to the local autozone to check eng codes. The dealer over here will charge 22000 YEN (about 220 dollars) just to hook up the scanner. my symptoms are: Horrible gas mileage (about 8-10 gallons in the city)...

Help, Im getting terrible gas mileage. The only thing I did was change the intake with a BBK CAI. The car idles correct and there are no engine codes. Power is there with no hesitations or stalling. WTF could the problem be?

HELP I need a new front adapter for my t56 tranny. Cracked while replacing the TOB retainer sleeve. (this is the housing that the tob retainer goes through). I remember seeing a thread with a link for the adapter plate with the retainer sleeve already installed.

Has anyone replaced this themselves. I ordered the new retainer from lethalperformance.com. Tranny is out, new clutch is installed already, just waiting for the sleeve to arrive. Looks like the sleeve is pressed in. How do I get it off? Hammer?: shrug: