I'm selling a set of rio red tail lights that were off my old '95 Cobra.
I sold the car and bought a GTO. So I no longer need these. :)
I have no idea what these go for but I know they go for a couple hundred new..
So I'll say $100 shipped?
Make offers!
There's one small scratch as shown in the...
Hey guys,
I got a ticket for modified emissions because I had a non CARB approved cold air intake. I have an appointment to see the state ref Monday.
My question is..I heard that they check your timing as well and that it can only be 2 degrees off. Is this true?
What else do they inspect...
OK guys,
Every once in awhile my car will take about 3 cranks to start up.
But a few days ago it took the car probably 7 times to start.
And today my car wouldn't start for a good 15 minutes.
I can hear the fuel pump priming..so does that eliminate the fuel pump as the problem?
What else...
OK guys...I can't figure this out.
I broke a valve spring on my '95 Cobra and had to drive it home (~5 miles) with it like that.
I replaced all of the valve springs with the trickflow upgraded valve springs and it runs fine now.
Only problem is now I have a ticking noise..from the bottom of...
OK so after buying a used set of 2003 Cobra lower control arms that weren't in the greatest condition, I went ahead and bought a brand new set from 50resto.
Before I had tons of noises coming from the front end: creaking, squeaking, popping. And my 9" rims rubbed on the sway bar.
Now I...
Sorry I don't know if this is the right place to post this?
But, one ball joint on the 2003 Cobra LCAs that I purchased has a gash in the threads where it looks like the guy sawed off the nut or something.
So if I can't get the castle nut back on there...I might be getting a new set of ball...
Hey guys I have a quick question for you.
I purchased some 2003 lower control arms and it looks fairly simple to install.
But, I'm not sure how to remove the springs.
I rented a spring compressor from Autozone but the bolt on it was way too long.
Is there any write-ups or anything on how to...
Well after close to 20 hours of making brackets for my new seats...they are finally in!
Those were the biggest PITA, unless I'm really that bad at making brackets. haha
Also I installed the leather e-brake boot & leather shortened shift boot from Redline Goods!
I apologize for the bad pics...
Finally got around to taking some pictures! :)
So here's my plan for the rear...tell me what you guys think.
Tint the tail lights
Black vinyl "MUSTANG" overlays
Paint the very bottom of the bumper black
And this billet 5.0 emblem in place of the blue ford emblem
MUSTANG-UPR Products.com...
OK guys I found a Cobra R carbon fiber hood for sale locally for VERY cheap...
What do you guys think that would look like on a Rio Red Cobra?
Would it look to ricer? :/