03 cobra black KB 2.2, new built short block, updated heads(UPDATE)
I'm going to start to demod this car by the weekend. Found a bike that I like at a dealership and they are willing to do a deal that Is fair to both of us.
Make a serious offer......or look for a ton of parts next week for sell in the terminator part section. Hate to do it this way....but I also dont want to try and sell the car for 3 months
Hi
Hate to sell it, but I just don't drive it much any more (been doing stuff to a 07 F150). The car has 38k miles, I'm the original owner...bought the car new in May 03. The car at about 34k had a damaged piston #7... so at that point I had a local ford dealer pull the motor for me. I then took the short block and had it built and then back to the dealer for them to reinstall it. The motor was done .20 over with new CP pistons and rings, it has new 05 updated heads both driver and pass. These are the new heads that ford made to correct the head tick problem that some of these cars gets. All was done using ARP head,main,rod bolts. The KB 2.2 and new motor all have less the 4k on them. I bought a nitrous kit for it but have yet to finish the install (needs the main line ran from the trunk to the motor).This motor and blower have never been sprayed. The car has a Alpine stereo/dvd system with a 6 disk MP3, amps and crossover in it with all speakers replaced and a JL sub. The car has lots of mods all over...Ill try and list what I can remember but I'm sure I'm forgetting some stuff. I have all receipts for the motor build and the new heads. I also own the Diablosport chipmaster software and will provide any custom tune you may need.
Thanks for looking.
mod list
KB 2.2L
new built short block .20 over
CP pistons and new rings
updated 05 heads both sides
new oil pump billet
Metco 6# lower pulley
3.1 and 2.93 billetflow pulleys
full set of billetflow idler pulleys
new 200 amp alt
mac long tube headers
mac H mid pipe with cats
magnaflow cat back 5 inch tips
18"x9 up front with275/35vr 18"x10.5 rear with 335/30vr michelin pilot sports
new interstate battery
Kenny Brown sub frames
Steeda tri-ax
C&L intake
steeda CAI
KB bap
plx wideband
NX iceman nitrous wet kit
billetflow IRS brace
hawk brake pads all around
LFP heat exchanger
Eibach springs
intercooler temp guage
P Fab ice box
billetflow hood vents
accufab single blade t/b
Killer Chiller ...never got it on the car.... comes with the sale
chrome cobra door sills
boost overlay
Raptor shift light
diablosport predator tuner
160 thermostat
I will add to the list as I can think of more stuff the car has. Most of these pics were at the end of summer. I can get more if you need. I would like to get $25,000 obo if you have any questions please give me a call
303-929-4337 Joe
Thanks
I'm going to start to demod this car by the weekend. Found a bike that I like at a dealership and they are willing to do a deal that Is fair to both of us.
Make a serious offer......or look for a ton of parts next week for sell in the terminator part section. Hate to do it this way....but I also dont want to try and sell the car for 3 months
Hi
Hate to sell it, but I just don't drive it much any more (been doing stuff to a 07 F150). The car has 38k miles, I'm the original owner...bought the car new in May 03. The car at about 34k had a damaged piston #7... so at that point I had a local ford dealer pull the motor for me. I then took the short block and had it built and then back to the dealer for them to reinstall it. The motor was done .20 over with new CP pistons and rings, it has new 05 updated heads both driver and pass. These are the new heads that ford made to correct the head tick problem that some of these cars gets. All was done using ARP head,main,rod bolts. The KB 2.2 and new motor all have less the 4k on them. I bought a nitrous kit for it but have yet to finish the install (needs the main line ran from the trunk to the motor).This motor and blower have never been sprayed. The car has a Alpine stereo/dvd system with a 6 disk MP3, amps and crossover in it with all speakers replaced and a JL sub. The car has lots of mods all over...Ill try and list what I can remember but I'm sure I'm forgetting some stuff. I have all receipts for the motor build and the new heads. I also own the Diablosport chipmaster software and will provide any custom tune you may need.
Thanks for looking.
mod list
KB 2.2L
new built short block .20 over
CP pistons and new rings
updated 05 heads both sides
new oil pump billet
Metco 6# lower pulley
3.1 and 2.93 billetflow pulleys
full set of billetflow idler pulleys
new 200 amp alt
mac long tube headers
mac H mid pipe with cats
magnaflow cat back 5 inch tips
18"x9 up front with275/35vr 18"x10.5 rear with 335/30vr michelin pilot sports
new interstate battery
Kenny Brown sub frames
Steeda tri-ax
C&L intake
steeda CAI
KB bap
plx wideband
NX iceman nitrous wet kit
billetflow IRS brace
hawk brake pads all around
LFP heat exchanger
Eibach springs
intercooler temp guage
P Fab ice box
billetflow hood vents
accufab single blade t/b
Killer Chiller ...never got it on the car.... comes with the sale
chrome cobra door sills
boost overlay
Raptor shift light
diablosport predator tuner
160 thermostat
I will add to the list as I can think of more stuff the car has. Most of these pics were at the end of summer. I can get more if you need. I would like to get $25,000 obo if you have any questions please give me a call
303-929-4337 Joe
Thanks
Last edited: