I installed Brembo brakes from a Ford GT and 14" rotors this weekend at a friend's place. They turned out great and definitely have more bite. Now my question is: the top of the pedal is squishy, is that just the amount of fluid it takes to get the pistons out enough for the pads to engage the rotors? Or do I still have air in the system? I bled all four corners starting furthest from the master cylinder and the brakes were basically non-existent and then I realized that I needed to bleed the master cylinder which firmed them up, but the first bit of pedal travel does nothing still. Am I paranoid since I just worked on them? They seem to stop good after that initial sponginess.